- wan.ipv6.transport = "ppp": IPv6CP in pppd, router advertisements and
DHCPv6 prefix delegation on the PPP device, DHCPv6 accepted on the PPP
device, IPv6 MSS clamped to MTU-60. Allowed on a shared single-NIC
link. A build-time check requires a PPPoE uplink.
- IPv4 MSS clamping now only matches IPv4 packets.
- The example uses the new box's NIC name (enp2s0).
Covered by the onestick VM test (radvd and a minimal DHCPv6-PD
responder as the ISP) and assertion cases.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
- Allow the WAN link to also carry LANs when the uplink is PPPoE on a
VLAN with IPv6 off; only the PPP device counts as an uplink then, so
LAN traffic can never match WAN rules.
- Add router.rollback: router-arm / router-confirm / router-rollback
plus `nix run .#deploy`, a commit-confirm deployment flow.
- Wait for the LAN devices instead of the uplink in networkd
wait-online, so an unplugged uplink cannot block boot or activation.
- Add examples/desktop (single NIC, PPPoE on VLAN 1001) as
nixosConfigurations.example, built as a flake check.
Covered by the onestick and rollback VM tests and new assertion cases.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
Extend router.firewall.rules with a reserved `wan` source zone: DNAT
(dnat, toPort), port ranges, source allow-lists, per-source rate
limits, logging and optional hairpin NAT. IPv6 is opened only by
explicit pinholes. Build-time assertions require WAN rules to name a
destination, protocol and ports so a typo cannot expose a whole zone.
Covered by the basic/pppoe VM tests and the assertion tests.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
router.wireguard.<name> configures tunnels through networkd: road warrior
(listening, dual-stack), site-to-site (no transfer network) and provider
dial-out with masquerade. A tunnel has a zone like a LAN, so inter-zone rules
apply; management, DNS and internet are opt-in. Peers' allowedIPs become
routes (destination-based routing; default-route tunnels are rejected).
Tunnels have a kill switch (default on): forwarded packets for their
allowedIPs are dropped if they would leave via an uplink, before the
established-accept so flows that used the tunnel are cut too.
Private keys stay outside the Nix store and are passed to the unprivileged
systemd-networkd with LoadCredential, so key files can be root-only.
Assertions cover CIDR/key/endpoint formats, duplicate allowedIPs, overlaps
with LAN subnets, port and device clashes, and rule destinations inside
tunnel networks. A five-VM `wireguard` check covers road warrior, site-to-site,
the provider tunnel with an IPv6 transfer net, zone rules and the kill switch.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
LANs can sit on an 802.1Q VLAN (`vlan` on a trunk `interface`); networkd
creates the device and brings the trunk up. LANs belong to a named `zone`
(default: their own name). Traffic inside a zone is forwarded freely, traffic
between zones is denied unless a `router.firewall.rules` entry allows it
(protocol, ports, optional destination inside the target zone).
Internet access is now opt-in per LAN (`internet`, default false), replacing
the previous allow-out default. Assertions reject unknown zones, bad
destinations, duplicate devices, over-long device names and a WAN trunk.
Kea subnet IDs now come from the network address so adding LANs does not
renumber them and orphan persistent leases.
Tests: a five-VM `vlans` check (untagged + two VLANs, shared zone, one-way
rules, per-host destination restriction), new assertion cases, parseNet unit
tests, and shared test tooling in tests/common.nix.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
IPv6: router.wan.ipv6.enable mirrors the existing uplink config (DHCPv6 with
WithoutRA=solicit, delegated prefix). The ISP delegates a single /64, so
exactly one LAN may claim it via router.lans.<name>.ipv6.pd (asserted); other
LANs stay IPv4-only. SLAAC only, no NAT66.
PPPoE: router.wan.ipv4.type = "pppoe" runs pppd on an optional VLAN of the
uplink, with the password read from a file at service start (never the Nix
store). NAT, forwarding and MSS clamping (MTU 1492) use the derived PPP
device; native IPv6 stays on the untagged link.
Tests: basic.nix is parameterised by uplink type; the pppoe variant uses a
fake ISP with pppoe-server (VLAN 7, CHAP). Both variants cover IPv6 PD, SLAAC,
routing without NAT and WAN-deny. Assertion tests gain PD/PPPoE cases and a
full-system evaluation step.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
router.* schema (wan, lans, dns.forwarders) compiled to systemd-networkd,
a generated nftables ruleset with NAT, Kea DHCPv4 and Unbound, plus build-time
assertions against lock-out and interface conflicts.
tests/basic.nix is a three-node VM test (upstream/router/client) covering WAN
DHCP, LAN DHCP and DNS, NAT, WAN-deny and LAN SSH/ping. `nix run .#lab` boots
the same topology in tmux with one console pane per VM and the driver REPL.
Co-Authored-By: Claude Sonnet 5.5 <noreply@anthropic.com>
nilsandClaude Sonnet 5.5